Magne
Flere idéer fra Magne
Pallet Raised Garden Bed More

Pallet Raised Garden Bed More

Pallet Raised Garden Bed More

Pallet Raised Garden Bed More

14238274_1046031252181493_8734875206452634193_n.jpg (462×960)

14238274_1046031252181493_8734875206452634193_n.jpg (462×960)

Slat Bench | Do It Yourself Home Projects from Ana White

Slat Bench | Do It Yourself Home Projects from Ana White

spoon carving jig                                                                                                                                                      Mais

spoon carving jig Mais

Love it

Love it

Micro-Adjustable Router Fence - Router Tips, Jigs and Fixtures | WoodArchivist.com

Micro-Adjustable Router Fence - Router Tips, Jigs and Fixtures | WoodArchivist.com

Cutting thin strips. To make the jig, attach a 5-in.-long strip of wood, 1/16 in. narrower than the width of the desired rip, to the end of a 1x6 as shown. Basically you're creating a horizontal push stick. Add a handle near the end of the jig to give yourself better control as you run the jig through the saw.

Cutting thin strips. To make the jig, attach a 5-in.-long strip of wood, 1/16 in. narrower than the width of the desired rip, to the end of a 1x6 as shown. Basically you're creating a horizontal push stick. Add a handle near the end of the jig to give yourself better control as you run the jig through the saw.

I came up with this joint a couple of years ago, when I was developing the Wonton Range. The obvious choice would have been to do a four way mitre, but they aren't that strong, prone to movement and difficult to clamp. I'm pretty sure this domino joint addresses all those issues. #furnituredesign@festool_usa

I came up with this joint a couple of years ago, when I was developing the Wonton Range. The obvious choice would have been to do a four way mitre, but they aren't that strong, prone to movement and difficult to clamp. I'm pretty sure this domino joint addresses all those issues. #furnituredesign@festool_usa

Small Parts Clamp  (Softer grip than pliers.)  The jaws of the clamp are made from a short section of 1 1/4" dowel. The dowel is split down the center and then the two halves are reassembled with a bolt, a wing nut and a few washers that space the "jaws" apart. A wedge inserted at the back of the clamp forces the jaws together.  Start by drilling the bolt hole through the dowel section and then tapering the jaw end with a sander. Cut the dowel and add the wedge.

Small Parts Clamp (Softer grip than pliers.) The jaws of the clamp are made from a short section of 1 1/4" dowel. The dowel is split down the center and then the two halves are reassembled with a bolt, a wing nut and a few washers that space the "jaws" apart. A wedge inserted at the back of the clamp forces the jaws together. Start by drilling the bolt hole through the dowel section and then tapering the jaw end with a sander. Cut the dowel and add the wedge.