Hans-Arne Hanssen

Hans-Arne Hanssen

Hans-Arne Hanssen
Flere idéer fra Hans-Arne
wooden automata | Hand-cranked wooden biplane automaton by Timberkits

wooden automata | Hand-cranked wooden biplane automaton by Timberkits

With the router running, now feed the square section into the infeed hole and rotate it against the cutter to start forming the dowel

With the router running, now feed the square section into the infeed hole and rotate it against the cutter to start forming the dowel

Wind the cutter up until the tip just lines up with the diameter of the outfeed hole

Wind the cutter up until the tip just lines up with the diameter of the outfeed hole

Fix the router under the table and set the cutter so that it protrudes through far enough for you to locate the block over it. Fix the support strip in this position by clamping it to the table at either end

Fix the router under the table and set the cutter so that it protrudes through far enough for you to locate the block over it. Fix the support strip in this position by clamping it to the table at either end

Now bolt this block to the middle of the support strip, having first drilled a central opening to allow some leeway when you are setting it up on the table

Now bolt this block to the middle of the support strip, having first drilled a central opening to allow some leeway when you are setting it up on the table

Next drill a hole through the face of the block of a diameter to match that of the cutter you are going to use to form the dowel

Next drill a hole through the face of the block of a diameter to match that of the cutter you are going to use to form the dowel

Sawtooth or forstner bits will leave a clean and accurate hole

Sawtooth or forstner bits will leave a clean and accurate hole

The important thing is that these two holes are concentric and they meet in the middle of the block. Use a drill press, drilling the larger diameter first and then following on with the smaller one

The important thing is that these two holes are concentric and they meet in the middle of the block. Use a drill press, drilling the larger diameter first and then following on with the smaller one

The finished dowl making jig (PHOTOGRAPHS BY ALAN HOLTHAM)

The finished dowl making jig (PHOTOGRAPHS BY ALAN HOLTHAM)

30 Amazing Diy Bottle Lamp Ideas

30 Amazing Diy Bottle Lamp Ideas